Spare parts for Dolphin EX 30

Replacement Parts for the Dolphin EX 30 Robot: Filters, Brushes, and Genuine Parts Maytronics

The Dolphin EX 30 is an electric pool cleaning robot manufactured by Maytronics and marketed under the brand Dolphin, a global leader in robotic pool cleaning. It is part of the EX series designed for residential pools that require an agile robot with good traction to clean the pool floor and walls.

Like all Dolphin robots, their replacement parts are organized into three main groups based on replacement frequency: cleaning consumables (filters and brushes, replaced every 1–2 seasons depending on use), mechanical traction parts (belts and tracks, when a loss of traction is detected), and electrical components (power supply, cable, and connectors, replaced as needed due to failure). The internal electronic and mechanical components have a long service life with proper maintenance.

At Quimipool, you’ll find the original Maytronics replacement parts for the EX 30. Since this model has several variations depending on the generation (basket or cartridge filtration, different cable lengths), we recommend contacting our technical support team by sending a photo of the unit and the serial number to confirm the correct part number before placing your order. You can also check out the complete section on pool cleaner replacement parts at Dolphin.

Related categories: Pool Cleaner Replacement Parts Dolphin · Pool Cleaners Dolphin · Automatic Pool Cleaners · Robot Pool Cleaner Replacement Parts · Electric Pool Cleaners

Dolphin EX 30: Model Specifications

Maytronics Original Replacement Parts for the EX 30 Dolphin

Filters: Clean after each cycle

Brushes: Adhesion to the floor and walls

Traction: tracks, belts, and bearings

Electrical: power supply, cable, and connectors

Mechanical: turbine and valves

Important note on availability: The EX 30 has different configurations depending on the generation, including variations in the filtration system (basket or cartridges), cable length, and some internal components. Before ordering any replacement parts, verify compatibility on the product page or contact our technical support team via the contact form by sending a photo of the unit and the serial number.

Brush Guide: How to Choose Based on Your Pool’s Finish

The most common mistake when replacing brushes is choosing the wrong type for the pool’s interior finish. The wrong brush causes the robot to slip on the walls or fail to climb onto the tile. Here’s a quick guide:

Preventive Maintenance: How to Extend the Life of the EX 30

Six basic rules to keep the robot in good condition for many years:

• Clean the filter after each cycle: a clogged filter reduces suction and overloads the motor. Remove the robot from the water, open the lid, and rinse the filter under the faucet after each use
• Inspect brushes and belts at the start of each season: if the rubber is worn or cracked, replace them before first use. Always replace belts in pairs
• Clean the propeller monthly: hair, roots, fibers, and fine debris accumulate on the motor shaft and gradually reduce suction without being immediately noticeable
• Do not leave the robot in the water between cycles: prolonged contact with chlorine (or a salt chlorinator, if applicable) degrades rubber and plastic much more quickly
• Store the cable without forced kinks: internal breaks in the self-floating cable are the leading cause of malfunction without visible damage. Store it in a loose loop; never bend it at a sharp angle
• At the end of the season: Clean the robot thoroughly, drain the water from inside, dry it, and store it in a dry place away from direct sunlight

Current Alternatives to the EX 30

If your EX 30 has multiple simultaneous malfunctions and you’d prefer to consider replacing it entirely with a newer model that has more readily available replacement parts, options are available in the catalog at Quimipool:

• Current Dolphin lineup: check the full catalog at Dolphin for current models from Maytronics
• Other brands in the catalog: Zodiac, Wybot, BWT, Hayward or Beatbot
• Cordless robots: If the cord has always been a weak point, consider cordless pool cleaners from Beatbot, Wybot, or iGarden

For the complete catalog by brand, check out the automatic pool cleaner hub.

Can’t find the replacement part for your Dolphin EX 30? Our technical team can identify the exact part based on the part number from the exploded view diagram at Maytronics or based on the issue you describe. Call us at 91 128 55 90 or contact us via the contact form, including a photo of the unit, the serial number, and the part to be replaced: Since there are variations by model generation in the filtration system and cable length, this is the fastest way to confirm the correct part number and avoid mistakes on your first purchase. See also pool cleaner replacement parts Dolphin, pool cleaners Dolphin, automatic pool cleaners, and robot pool cleaner replacement parts.