Saci, and Winner Pump Replacement Parts
- Spare parts pump Saci Pre-filter cap stopcock 92400013
- Pump replacement Saci Pre-filter cap 92400014
- Pump replacement Saci O-ring O-ring pre-filter cover 92400015
- Pump replacement Saci Pre-filter basket 92400016
- Spare pump Saci Kit connections pvc fitting 63 mm 92400158
- Spare pump Saci Mechanical seal 9012317L
| Position | Product | Quantity | Unit price |
|---|---|---|---|
| 1 |
Regular price
16,50 €
Sale price
Regular price
|
||
| 2 |
Regular price
22,91 €
Sale price
Regular price
|
||
| 3 |
Regular price
9,95 €
Sale price
Regular price
|
||
| 4 |
Regular price
12,29 €
Sale price
Regular price
|
||
| 5 |
Regular price
27,04 €
Sale price
Regular price
|
||
| 6 |
Regular price
15,95 €
Sale price
Regular price
|
Saci Winner Pump Breakdown: Parts List with Prices, Piece by Piece
The Winner is a pool pump from Saci, a Spanish manufacturer with a product line widely used in residential installations. This unit is easy to maintain: its breakdown focuses on the prefilter (cover, shut-off valve, gasket, and basket), the 63-mm connection kit, and the mechanical seal —the part that separates the hydraulic system from the motor.
If you’re looking for “the Winner Saci parts list,” here it is , complete with prices and an explanation of what each part does and when it needs to be replaced. All genuine manufacturer parts with a warranty.
A tip to avoid mistakes: the Winner is manufactured in various power ratings (100 M, 150 M, and others), but the parts list on this page—pre-filter, connections, and seal—is common to the entire lineup. What does vary depending on the power rating are the turbine, diffuser, and condenser.
Related categories: Saci pump replacement parts · Pool pump replacement parts · Pool pumps · Pre-filters for pumps · Replacement parts · Technical service
Saci Winner Parts List
Prefilter: the four parts that need to be cleaned every week
| Replacement Parts | Estimated price | What it does and when to replace it |
|---|---|---|
| Prefilter cover O-ring | €9.95 | The key component for priming. It seals the cover against the body; when it hardens or becomes compressed, air enters and the pump fails to prime—even if not a single drop of water comes out. Replace it if it does not spring back to its original shape when pinched. |
| Pre-filter basket | €12.29 | The basket that traps leaves, hair, and insects before they reach the impeller. The most frequently replaced part: it cracks from sun exposure or breaks when removed while full. |
| Pre-filter Lid Locking Key | €16.50 | The locking mechanism for the cover. Replace if it is cracked or no longer locks securely. |
| Pre-filter cover | €22.91 | The transparent cover. Replace if it is cloudy (you lose the visual inspection), cracked, or if the gasket seat is damaged. |
Connections and hydraulics
| Replacement | Estimated price | What it does and when to replace it |
|---|---|---|
| Mechanical seal | €15.95 | The seal between the hydraulic assembly and the motor. If there’s a leak at the joint between the housing and the motor, it’s this part —and you shouldn’t ignore it: the water will eventually reach the motor. |
| 63 mm PVC Fitting Kit | €27.04 | A set of fittings for connecting to 63 mm pipes. The solution when there are leaks at the connection to the plumbing system or the fittings are damaged. |
Why Mechanical Seals Require Immediate Attention
Of all the parts on this page, the mechanical seal is the only one whose failure worsens rapidly on its own.
Its job is to seal the shaft between the part that moves the water and the part that drives it. When it fails, a constant drip appears at the joint between the housing and the motor —typically at the start of the season. And that drip:
- Eventually seeps into the motor, at which point the repair cost jumps from €15.95 to the price of a new pump
- Itprogresses rapidly once it starts
When replacing it, take the opportunity to check the condition of the shaft and clean the inside of the housing. And if you have any questions about disassembly, this is a good time to consult technical support.
Quick Diagnosis: From Symptom to Part
| Symptom | Most Likely Cause | Part to Check |
|---|---|---|
| Does not prime or loses prime | Air entering through the prefilter cover | O-ring (€9.95); then cap and shut-off valve |
| Bubbles inside the prefilter | Air entering the suction line | Gasket, lid seat, suction fittings |
| Leak between the housing and the motor | Mechanical seal worn out | Mechanical seal |
| Leak at the pipe connection | Damaged or improperly installed fittings | 63 mm connection kit |
| Leak around the cover | Expired gasket or cracked cover | Install the gasket first; then the cap |
| The shut-off valve won’t tighten | Cracked or worn valve | Lock |
| Leaves and hairs reaching the turbine | Broken or poorly seated basket | Pre-filter basket |
| Opaque cover | Sun-induced aging | Cover (check for visual issues) |
| It hums but won't start | Capacitor | Not listed on this page → contact us |
| Loss of flow with a clean filter | Turbine or diffuser | Not on this page → contact us |
Maintenance that extends the life of the Winner
- Empty the basket every week during the season. A full basket causes the motor to work against resistance, and is the indirect cause of half of all overheating incidents
- Lubricate the O-ring with silicone once or twice per season: it seals better, the lid opens smoothly, and the seal will last for years
- Close the lid by hand. The locking knob and threads are not designed to be forced open with a tool
- Winterization: Drain the pump housing and leave the prefilter dry. Frozen water inside the housing is the classic winter-related failure
- Check the fittings at the start of the season: the connections to the piping are affected by temperature cycles
- Keep it in the shade if possible: the transparent lid will appreciate not being exposed to direct sunlight all year round
Looking for a part for your Winner Saci that you don’t see here? Call us at 91 128 55 90 or send us a message via the contact form with a photo of the pump, the nameplate, and the part to be replaced —we work with the manufacturer’s complete parts list. And keep these two key points about this pump in mind: the €9.95 O-ring solves most “won’t draw water” issues, and a leak between the housing and the motor can’t wait. See also spare parts for Saci pumps, pool pump spare parts, pre-filters for pumps, and technical service.
